Support for
If your job is going to be die-cut, and the product allows custom formes, then it is acceptable to use any combination of cuts, perforations, creases and punched holes, providing that the total number of 'anchor points' does not exceed the maximum allowed, dependant on the flat size of the product.
| Flat size | Anchor point limit | |
|---|---|---|
| Simple | Complex | |
| Smaller than A4 | 15 | 23 |
| A4 or larger | 20 | 28 |
The complex forme finishing option is available for most die-cut products and carries and additional charge.
Count the 'anchor points' (including endpoints), but not the manipulation handles. Each punched hole counts as 2 anchor points.
Jump to contents page of
|
|||